Posts by old_user45740

1) Message boards : climateprediction.net Science : run crashing repeatedly. (Message 25534) Posted 9 Dec 2006 by old_user45740 Post: I haven\'t really been watching my BIOINC project very close like I probably should have been for while now. I just realized today after wondering why my project always seemed to be going but never seemed to be finishing for the past number of months now. I looked at the log and realized that it was because the thing was crashing after a while repeatedly.. :( So I reset the project as it suggested and loaded new work. I was just curious if this has been happening to anyone else? I am using BIOINC 4.45 and unfortunately after I started a new on I wondered if I should have upgraded BIOINC first. It could be that I have been having problems with my machine blue screening on me every once in a while and maybe something got corrupted. I did finally figure out that it was the audio driver that was being named in the crash dump for the on board chip set. So I decided to buy a new audio card, since I had a little noise issue on it anyhow. So I hope that gets rid of my machine crashing problem. Here is the error I was getting below from rouply every hour to eight hours. 12/8/2006 2:50:24 AM\|climateprediction.net\|Result hadcm3lbm_a9w7_05248650_0 exited with zero status but no \'finished\' file 12/8/2006 2:50:24 AM\|climateprediction.net\|If this happens repeatedly you may need to reset the project. 12/8/2006 2:50:24 AM\|\|request_reschedule_cpus: process exited Thanks,
2) Questions and Answers : Windows : still can\'t upload to uploader1..anyone else? (Message 9658) Posted 20 Feb 2005 by old_user45740 Post: Thanks, I noticed later that there is still stuff going on in that thread. It was just a bit confusing on that what was going on exactly. But I am assuming everyone else is definently haveing the same issue at least if there result is trying to use the uploader1 server anyway.
3) Questions and Answers : Windows : still can\'t upload to uploader1..anyone else? (Message 9622) Posted 20 Feb 2005 by old_user45740 Post: I just got my first work unit done a few days ago and it still hasn't been able to upload anything yet. I had found another thread where people seemed to indicate that the upload server was down, but I would think it would be the hot topic of the day if that were still the case, and haven't seen much more talk about it lately. Anybody out there have some more insight than me on this? I decided to try upgrading to 4.19 but didn't make any difference. I have been able to send trickles out fine so, but I was worried if my router was blocking something. If it is then I am stumped on how to fix it. I turned my firewall off on my computer and that didn't seem to make a difference either.