Something seriously terminal has happened to my Sulphur run. With fewer than 600 hours to go on an estimated 3400 hour run, there was a series of \"scheduler request unsuccessful\" messages to do a trickle up. Then there was a \"scheduler request succeeded\" message followed by an error message to the effect that a result was never sent. Unfortunately I don\'t have the message file, because of a computer restart. Climateprediction remains a project, but there is no running task, even after the restart.
BOINC 5.4.9, latest result 1316055, work unit 858255.
dataout contains a restart.day, phist.day and a thist file all with the same time stamp. yabsd.out file has a time stamp 6 minutes later. It has the message
SLAB TIMESTEP 1125
3395537 words long
MODEL DUMP SUCCESSFULLY WRITTEN - 3434914 WORDS TO UNIT 22
followed by eight REPLANCA update required messages, followed by (incomplete)
REPLANCA: UPDATE REQUIRED FOR FIELD 74
REPLANCA - time interpolation for field 74
The last few messages on stderr_um.txt are:
OPEN: File dataout/dqcuea.da74110 Created on Unit 22
CLOSE: WARNING: Unit 66 Not Opened
OPEN: File dataout/dqcuea.pg74jan Created on Unit 66
CLOSE: WARNING: Unit 67 Not Opened
OPEN: File dataout/dqcuea.ph74jan Created on Unit 67
CLOSE: WARNING: Unit 68 Not Opened
OPEN: File dataout/dqcuea.pi74jan Created on Unit 68
OPEN: File dataout/dqcuea.da74140 Created on Unit 22
OPEN: File dataout/dqcuea.da74170 Created on Unit 22
OPEN: File dataout/dqcuea.da741a0 Created on Unit 22
OPEN: File dataout/dqcuea.da741d0 Created on Unit 22
OPEN: File dataout/dqcuea.da741g0 Created on Unit 22

File dataout/dqcuea.pi74jan is the last file created in dataout before the restart.day file.
Anything to be done?

---

If the model in question is NOT in the Tasks tab, and/or you don\'t have a backup, then there\'s nothing that you can do. But the important info needed for the new TCMs was all in the upload at the end of phase one.

Les, if that\'s the case, I\'d like to clear out all old files, projects etc
and start again. Selecting the project and clicking \"Reset Project\" has no effect.
Can I manually delete all files and directories with \"climate prediction\" in the name (including the .xml files)?
Thanks
Graeme

---

I\'m not sure if Reset will delete folders, but if it does, it will only be for currently running models.
Everything else is DIY.

Only delete the folders under C:\\Program Files\\BOINC\\projects\\climateprediction.net
These folders will have names like: sulphur_482a_000297346
(Which was my one and only sulphur model.)