work unit uk met office hadsm3 slab model 5.06 start date 1810 has no graphics (it did before) its now over 13 % it is running clicking away time and cpu ; is it ok or does it need to be restarted?

---

All the slab models have that description, so we\'ll need a bit more than that.
Either the Result ID number, or the first part of the name; e.g. hadsm3fub_0348, which is one of yours.

However, loss of the graphics is usually something to do with your computer, rather than the model.

One thing that you could try is to Exit from BOINC, and then reboot the computer, which can cure a number of ills. (Use Exit in the BOINC menu!)

---

Backups: Here

There is a known but unresolved problem with slab model graphics after phase changes (see here). However, 13% doesn\'t get the model into phase 2.

In any event, Les\'s suggestion of an exit (and a re-boot, if required) is the prescribed remedy.

the number of this slab model is HADSM3FUB_oo5895977_2 the graphis will rotate and the colors are solid except for pressure and that gives an outline of the land masses ,

1. Did you re-boot the machine as suggested?

2. Any other graphics anomalies on the machine lately? Are the drivers up to date?

---

"We have met the enemy and he is us." -- Pogo
Greetings from coastal Washington state, the scenic US Pacific Northwest.

What I am primarially concerned wiyh is the model running properlyI have exited and shut down and restarted and rosseta graphics are ok drivers are new as is the system 41 hours 14% run I simply do not weant to allow a bad module to waste time running if everyone thinks its ok then I am good with that thanks Robby

The page on the server for that model is here.
It\'s a \'slab\' model, (non-dynamic ocean), so there won\'t be any graphs available on the server page until you complete phase 1. (And phases 2 and 3.)

There are 3 ways to see if it\'s OK:
1) Trickles continue to appear at the bottom of the above page;
2) The message: Reason: To send trickle-up message continues to appear at intervals in the Messages tab of your BOINC manager;
3) No error messages appear in the Messages tab of your BOINC manager.

1) Looks OK, but only you can check on 2) & 3).

---

Backups: Here